Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Cutting binds or burns work.
Workpiece edges away from rip fence
when ripping.
Saw does not make accurate 90˚ or
45˚ cuts.
Height/bevel adjusting hand-wheel
is hard to turn.
Saw does not start.
Blade makes poor cuts.
Blade does not lower when turning
height/bevel adjusting handwheel.
Motor labors in rip cut.
Blade coasts for longer than a few
seconds after the saw is turned off.
TROUBLESHOOTING
CAUSE
Blade is dull.
Blade is heeling.
Work is fed too fast.
Rip fence is misaligned.
Workpiece is warped.
Riving knife is out of alignment.
Blade not properly sharpened or set.
Positive stops behind the front panel
need adjusting (Bevel Cuts).
Miter gauge is misaligned (Miter Cuts).
Gears or screw post behind the front
panel are clogged with sawdust.
Motor cord or wall cord is not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Blade is dull or dirty.
Blade is wrong type for cut being made.
Blade is mounted backwards.
Locking lever is not at full left position.
Blade not proper for rip cut.
Braking system may not be working
properly.
44 - English
SOLUTION
Replace or sharpen blade.
See Adjusting the Blade Parallel to the
Miter Gauge Groove (Removing Heel).
Slow the feed rate.
Align the rip fence.
Replace the workpiece. Always cut with
convex side to table surface.
See To Check and Align the Riving Knife
and Saw Blade in the Assembly section.
Resharpen or set blade.
Adjust positive stops.
Adjust the miter gauge.
Clean the gears or screw post.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have the cord or switch replaced at your
nearest authorized service center.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Move locking lever to left.
Change blade; rip blade typically has
fewer teeth.
Contact customer service.
Publicidad
