Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION WITH REMOTE BLOWER (RB900 / RB1200) OR IN-LINE BLOWER (INLBKIT)
NOTE: FOLLOW THE INSTRUCTIONS INCLUDED WITH THE REMOTE BLOWER TO
INSTALL THE BLOWER ON THE OUTSIDE OF YOUR HOME.
1. Install the Plate B with the second wiring box
(Figure 13) which came with the remote blower kit,
on top of the rangehood. Use 9 screws supplied with
the blower kit. Remove the electrical knockout hole
on top of the plate.
FIGURE 21
FIGURE 13
2. Remove the white plastic covering and Install the
4 side trim pieces (4-5) to the outside of the hood
using (14) part 9c screws, see the side rail installation
in (Figure 14).
9c
5
4
FIGURE 14
B
nd
2
wiring box
6 hole end
nd
2
wiring box
4
3. Connect the wire coming out from the 2
to the 6 hole end of the 1
Connect the wire that comes out from the black box of
the electronic board to the 9 hole end of the 1
box (Figure 15).
st
1
wiring box
FIGURE 15
4. Pass the remote blower cable through the
knockout hole in step 1 (Figure 13,16). Connect this
cable from the remote blower to the 2
placed on the lower surface of plate B.
FIGURE 16
5. Follow step 4 on page 13 to connect ducting,
wiring, and test the electrical connection. Use the
wiring box connected to the inside wall of the hood
which connects to the home power supply thru the
knockout on the side of the hood.
5
nd
wiring box
st
wiring box.
6 hole end
nd
wiring box
st
wiring
11
Publicidad
