Publicidad
Idiomas disponibles
Idiomas disponibles
3. Install the motor kit into the back of the hood
using the 2 screws supplied with the motor kit
(Figure 4).
FIGURE 4
4. Connect the wire cable D (which is located
inside of Kit Internal 300 cfm Blower sku #; IB300
or Internal 400 cfm Blower sku #; IB400 or Internal
600 cfm PRO Blower sku #; IB600).
Connect the 6 hole end to the wire box and connect
the 9 hole end to the motor (Figure 5).
9 hole
D
6 hole
end
9 hole end
9 hole end
FIGURE 5
end
6 hole
end
5. Connect the ductwork to the damper and seal all
connections with duct tape.
6. Before installing the hood, put the damper A
(which is located inside of Kit Internal 300 cfm
Blower sku #; IB300 or Internal 400 cfm Blower
sku #; IB400 or Internal 600 cfm PRO Blower sku
#; IB600. Figure 6).
A
FIGURE 6
9
Publicidad
