Publicidad
Idiomas disponibles
Idiomas disponibles
Rangehood Control Panel
The control panel is located in the center of the
hood bottom.
A
Light On/Off Button (A)
On/Off switch for the lights. Position "0" turns the
lights Off, turning the switch to the right is On.
Blower On/Off Button (B)
On/Off switch for the blower. Move the dial to the
right to turn the blower ON and vary the speed of
the blower. Turn to the left at "0" to turn it OFF.
For Best Result
Start the rangehood several minutes before
cooking to develop proper airflow. Allow the unit
to operate for several minutes after cooking is
complete to clear all smoke and odors from the
kitchen.
Cleaning
The stainless steel grease filters and grease rail
should be cleaned frequently in hot detergent
solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available
stainless steel cleaner. Abrasives and scouring
agents can scratch stainless steel finishes and
should not be used to clean finished surfaces.
Make sure the grease filters are completely dry
with no water present before re-installing into
hood.
Grease rail and Grease Filter Installation /
Removal.
Remove the plastic from the filter, the knobs
need to be installed onto the filter with 2
screws to each filter.
16
B
Install the grease rail into the back of the hood,
into the slots on the inside floor of the rear of the
hood. The Grease filters should be installed before
operating the rangehood. To install the filters, use
the two knobs to hold the filter and insert the filter
into the front edge of the hood with the knobs
facing out into the spring loaded slot. Install the
other end of the filter above the grease rail in the
back of the hood.
Lighting unit
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly
into the housings on the lamp holder.
a
b
Gu10 self-ballasted led lamps
– listed in accordance with ul
1993/nmx-j-578/1-ance/csa
c22.2 No. 1993
a
b
Publicidad
