Publicidad
Idiomas disponibles
Idiomas disponibles
Selection of saw blades (Fig. 8)
• Always use cutting tiles to the diamond wheel (D)
• Use of wood TCT saw blades always the (E).
• Always use plastic and Alumionium the HSS saw
blade (F)
Change the saw blade (Fig. 9+10)
• Set cutting depth to maximum
• Press button and hold the spindle lock button (16)
• Use inner hexagon wrench to loosen and remove
the flange screw (8)
• Press the safety lock button (3) to lift up the base
plate (18)
• Change saw blade and fix them in reverse order
• Attention: The saw blade continues to rotate
after the machine is switched off.
13. Maintenance
Don't clean or do maintenance on the machine
while it is still connected to the power supply.
The machine requires little maintenance and con-
tains little parts that must undergo the operator of a
service. Faults or defects that may affect the safety of
the machine must be rectified immediately.
Notice:
Clean your machine regularly after every usage
– it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively
trained professionals only!
• Check regularly the condition of the security stick-
ers. Replace them if required.
• Check regularly the condition of the saw band and
the saw band guide.
• The good condition and perfect adjustment of the
guiding rollers is essential for a smooth band guid-
ance and a clean cut.
• Store the machine in a closed, dry location.
Maintenance plan
• After each workshift: Remove chips and dust
from the device
• After 10 hours of operation: When working metal
it is possible for conductive dust to settle in the in-
terior of the power tool. The total insulation of the
power tool can be impaired. Blow out the interior
of the power tool via the ventilation slots with com-
pressed air.
Cleaning
After each workshift the machine has to be cleaned.
Remove chips etc. with a suitable tool. Do not remove
them by hand (cutting injury!). Remove dust as well.
24 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Notice
The usage of certain solutions containing ingre-
dients damaging metal surfaces as well as the
use of scrubbing agents will damage the ma-
chine surface!
Clean the machine surface with a wet cloth
soaked in a mild solution
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brush, saw blade, batteries
* Not necessarily included in the scope of delivery!
14. Storage
Store the device and its accessories in a dark, dry
and frostproof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical
tool.
15. Electrical connection
The installed electric motor is completely wired
ready for operation.
The customer's connection to the power supply
system, and any extension cables that may be
used, must conform with local regulations.
Defective electrical connection cables
Electrical connection cables often suffer insulation
dam age. Possible causes are:
• Pinch points when connection cables are run
through window or door gaps.
• Kinks resulting from incorrect attachment or laying
of the connection cable.
• Cuts resulting from running over the connecting
cable.
• Insulation damage resulting from forcefully pulling
out of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must not
be used as the insulation damage makes them ex-
tremely hazardous.
Check electrical connection cables regularly for
damage. Make sure the cable is disconnected from
the mains when checking.
Electrical connection cables must comply with the
regulations applicable in your country.
Publicidad
