Publicidad
Idiomas disponibles
Idiomas disponibles
Reassembly
To reassemble:
1. Install the nozzle seal with the groove (a)
(slot) facing toward the nozzle (away from
the front end assembly).
Insert the nozzle. Make sure to align the
groove (b) and notch (c) and align the
nozzle opening with the needle.
2. Put the air cap (d) on the nozzle (e) and
secure with the connecting nut (f).
3. Snap the adjustment ring (g) into the
connecting nut, enabling the adjustment
lever (h) on the peg (i) to be positioned in
the air cap.
note: Make sure that the two recesses on the
adjustment ring are engaged in the air cap tabs.
4. Place the container seal on the suction
tube and slide it over the collar (j), while
turning the container seal slightly.
5. Insert the suction tube with the container
seal into the front end assembly.
6. Replace container.
Transportation / storage
1. Coil power cord around the basic unit.
2. Insert spray gun into spray gun holder on
the device.
3. Coil the air hose around the main turbine,
starting at the spray gun end. You may
need to remove and replace the end of the
hose that connects to the turbine.
IMPORTanT: DO nOT attempt to remove the
air hose from the gun handle.
English
Start
IMPORTANT:
Follow the steps described below for
reassembly. Improper reassembly can result in
damage to the spray gun assembly.
1
a
b
c
3
h
g
5
12
2
f
4
i
j
6
e
d
Publicidad
