Publicidad
7.0
LABELS and MARKINGS
7.1
LABELS: Figure 9 illustrates labels present on the product. Labels must be replaced if they are not present or are not fully
legible. Information provided on each label is as follows:
;
Label images are intended to be representative. Please refer to your product label for specific information.
SPECIFICATIONS: Capacity: 1 Person, ANSI 310 lbs (140 kg) max, OSHA 420 lbs (190 kg) max.
1
Maximum arresting force 1,800 lbs
Materials: Aluminum anchor; Zinc plated alloy steel D-ring
Standards: Meets ANSI Z359.18 Type A and OSHA 1926.502 & 1910.140
Minimum Breaking Strength: 5,000 lbs (22kN) MBS
ANSI Minimum Service Temp. -40F (-40C)
USE: See User Manual for details on making connections. Do not allow lifeline to abrade against sharp edges during
2
use. Use caution when using this equipment near hazardous thermal, electrical, or chemical sources. Refer to User
Manual for additional information.
INSPECTION: Inspect anchor before each use. At least monthly, anchor should be inspected by a competent person
3
in accordance with the User Manual. Do not use if inspection reveals an unsafe or defective condition. Not user
repairable.
This product is RFID enabled and contains an electronic tag that can be read by compatible readers - providing
inspection and other safety information.
ALLOWABLE LOADING DIRECTIONS: Never work at a horizontal angle greater than 30° from perpendicular to the
4
face of the SRD to avoid improper loading of the Anchorage Connection Point. Never work at a position above or
below the Anchorage Connection Points that exceeds the vertical load requirements.
This door/window jamb must be installed at the bottom of the window or door Opening, resting on the sill. If the
5
anchor is not resting on the sill it may rotate. When loaded, allowing the anchor to come free of the window or
door opening. Failure to follow this warning may result in serious injury or death.
6
CE Standard and Notified Body ID
7
Year/Month Manufactured and Lot Number
Manufacturer's instructions must be read and understood prior to use. Instructions supplied with this product
8
at time of shipment must be followed for proper use, maintenance and inspection. Alteration or misuse of this
product, or failure to follow instructions could result in serious injury or death. Make only compatible connections.
See user manual.
9
Product Model Number
Manufacturer's Location
10
One Person Maximum
11
Usage Temperature Range: -40°C to 60°C
12
Inspection Log: Date, Initials
13
8.0
RFID Tag
8.1
LOCATION: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 8
for where your RFID Tag is located.
8.2
DISPOSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For additional information on how to remove the RFID Tag, please refer to the website link below.
Do not dispose of your product as unsorted municipal waste. The crossed-out wheelie bin symbol indicates that
all EEE (Electrical and Electronic Equipment) must be disposed of according to local law through available return
and collection systems. Please contact your dealer or your local 3M representative for further information.
For more information, please visit our website: http://www.3M.com/FallProtection/RFID
9.0
GLOSSARY OF TERMS
9.1
DEFINITIONS: The following terms and definitions are used in these instructions.
;
For a comprehensive list of terms and definitions, please visit our website: www.3m.com/FallProtection/ifu-glossary
11
Publicidad
