TECO 36 SPECIAL Manual De Instrucciones página 82

3. UNWRAPPING
Pay careful attention when unpacking, assembling, handling and installing the
machine as described below. Failure to observe these instructions could damage
the machine and compromise operator safety.
Before removing the machine from the pallet, make sure the items shown below
have been removed.
Remove the upper part of the package
and make sure that the machine has not
suffered damage during transport; identify
the points for fastening to the pallet.
-The machine consists of
1 body
2 head
3 included
4 air tank (TI version only)
4. MOUNTING
- Remove the tower (horizontal + vertical
arms) from their position on the pallet.
- Free the mounting bar from the wooden
lath that is keeping it locked. During this operation it is advisable to keep the mounting bar
in lowered position with a hand.
- Assemble the bead breaker with the proper pin and fasten it with the locknut until there is
a slight resistance in the rotation of the bead breaker. (Fig. 5b).
- Remove side cover.
- Fit the tower and in the meantime insert pneumatic hose A into its proper hole on the
machine's body. (Fig.5a).
- Insert pin B on the tilting arm and fasten it with the proper screws, using the washers
provided (Fig.5a).
- Tilt arm C in vertical position and introduce pin D. Pin D must pass through the hole M of
the tower tilt cylinder's stem (Fig.5a)
- Lock the axle D with the split pin I and the snap ring L.
- Connect hose A to the valve placed on the pedal unit base inside the machine's body and
controlled by the horizontal arm swing pedal.
- Fit the side cover.
82
WARNING
WARNING
1
4
3
2
4
User's manual