Hella Comet FF 100 Instrucciones De Montaje página 11

Electrical connection:
Install relay with connection
terminals pointing downwards so
that they are protected against
splashing water (Fig. 5).
Final installation:
1. Lay ends of wires to lamps, insert
into lamp housing through rubber
grommet and crimp on cable
terminal (Fig. 7).
2. Install bulb (do not touch glass
with bare fingers).
3. Connect wire to bulb connection
and insulate. Attach earth lead to
retaining spring.
4. Arrest headlamp insert in
housing in proper position (Fig. 8).
("TOP" mark always upwards)!
11
If required, install switch in
dashboard: Either switch supplied
with set or special switch for your
vehicle (Fig. 6).
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according
circuit diagram (page 3).
5. Bolt lamp to vehicle, (if necessary
with 2-point mount).
6. Align lamps, tighten all bolts.
7. Reconnect battery earth lead (-).
Check lights. Fasten connection
securely.
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.
The use of the enclosed
protective caps is not permissible
in areas governed by German
Traffic Laws. However it is
permissible to use protective
grilles.
According to circuit diagram I the
auxiliary lamps are switched on
together with the existing main
beams.
According to circuit diagram II the
auxiliary lamps can be switched on
in addition to the main beams with
a separate switch.
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80 % of the light.
You drive more safely when you
can see and be seen well.
Do you have spare bulbs and
fuses in your vehicle?
If you have any questions or
installation problems: Ring the
Hella service department.