Eaton TRIPP LITE Serie Manual Del Usuario página 15

1. Closure Assembly
1.3 Install the Branching Cable
1
Turn over the splice tray and remove the nut for the branching cable from the
cable hole (Figure 1-22).
Note: The cable entry is only suitable for branching cable.
2
Loosen the two screws to remove the upper press clamping (Figure 1-23).
04-067-93-47C2_revA.indb 15 04-067-93-47C2_revA.indb 15
Figure 1-22: Remove the nut
Figure 1-23: Remove the press clamping
15
1/31/2024 10:40:53 AM 1/31/2024 10:40:53 AM