Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.3.1 - Error messages on the display
To cancel the error message on the display, after having eliminated the cause of the anomaly, perform a complete opening or closing
manoeuvre, i.e. until the relevant limit switch is reached. Alternatively, briefly press the
perform any movement).
MOTOR OVERLOAD
SAFETY EDGE
PHOTOCELL TEST
4.3.2 - Error messages on flashing light
The events reported in the following table are signalled by the flashing light and the KEY LED present in the control unit.
FLASHING INDICATION AND
LED KEY ON CONTROL UNIT
2 quick flashes + pause + 1 flash
4 quick flashes + pause, for three times
2 quick flashes + pause, for three times
5 quick flashes + pause, for three times
3 quick flashes + pause, for three times
6 quick flashes + pause, for three times
4.3.3 - Status messages on display
Repeatedly pressing the
press the
(MENU) button.
DISPLAY
,
4.4 - Autolearning of the travel stroke
Upon the first start-up or in the event of a modification of the
equipment model, which involves restoring the factory values, the
message
learning procedure of the operating parameters must be performed
(width of the movement angle of the doors, slowdown points in
10
auto-learning
Obstacle detected
Photo1 / Photo2
Safety edge
The photo test has
Short circuit
(UP) button displays additional information described in the following table. To return to the normal status,
,
,
, ecc.
appears on the display and the auto-
The current of a motor has increased very rapidly
1. The gate has struck an obstacle
The control unit has detected the activation of the safety edge
1. The safety edge is active
2. The safety edge is not connected correctly
The photocell or safety edge test has failed
1. Check the correct functioning of the photocells
2. Check the photocell connections
EVENT
DESCRIPTION
Auto-learning phase in progress
A leaf has struck against an obstacle
A photocell has been activated
The safety edge has been activated
The photocells or sensitive edge test has failed
failed
Anomaly in one of the FLASH, ELS/SCA or LED outputs
overload
MEANING
Automation status
Total number of complete opening + closing manoeuvres
Instantaneous current absorbed by motor M1, in mA
Card type – firmware version – card serial number
opening and closing, ...).
WARNING
auto-learning procedure (
Advanced parameters).
MENU button (the automation does not
!
Select the correct motor before starting the
, paragraph 5.2 -
Publicidad
