Publicidad
Idiomas disponibles
Idiomas disponibles
4.5.3 - Deletion of the entire receiver memory
Exit any menu, press and hold the
.
1. Press and hold down the
seconds); keep the button
2. After releasing the button the KEY LED starts to flash slowly; count the flashes.
3. At the third flash, briefly press the button
4. A long flash of the KEY LED indicates that all the radio remote controls have been deleted.
5. The control unit exits the
(MENU)
4.5.4 - Memorisation of a button of a new radio remote control using a radio remote control already saved
in memory
It is possible to add the button of a new radio remote control to a control unit in which at least one
radio remote control has already been memorised
1. Near the control unit, press and hold the button of the new radio remote control to be added to the control
unit for at least five seconds
2. Near the control unit, press and hold down for at least three seconds the button of the already mem-
orised radio remote control to which the function to be duplicated on the new radio remote control is
associated.
NOTE: if step 1. has been correctly performed, the automation does not perform any manoeuvre and
it is possible to proceed with memorisation.
3. Near the control unit, press and hold the same button on the new radio remote control used in point
1 for at least three seconds.
4. Near the control unit, press and hold the same button on the old radio remote control used in point 2
for at least three seconds.
NOTE: the procedure has been correctly performed if the automation executes the command just
memorised.
If the procedure is not completed, after a few seconds the control panel receiver returns to normal
operation.
4.6 - Factory parameters reset
To return all the parameters to their default values or to change the type of equipment on which the control panel is installed, proceed
as follows:
!
WARNING
If the motor type is not changed, the following procedure restores the default values and it is not necessary to re-
learn the stroke.
1. Press and hold the button
2. Scroll through the menu items with the buttons
3. Press and hold the button
of motor in use.
4. Select with the buttons
The display shows a countdown from 50 to 0; release the button when the text
5. The control unit exits the MENU after seven seconds of inactivity or by briefly pressing the
!
WARNING
If the type of motor is changed, all the values are returned to the factory value and it is necessary to perform a new
auto-learning procedure for the travel.
(DOWN-RADIO) button until the display alternately shows
(DOWN-RADIO) button until the KEY LED lights up (approximately three
(DOWN-RADIO) pressed until the KEY LED turns off; release the button.
(DOWN-RADIO).
after seven seconds of inactivity or by briefly pressing the button
(MENU); the display shows in sequence
(UP) and
(MENU); release the button when the display starts flashing; the number displayed indicates the type
(UP) and
(DOWN-RADIO) the type of motor; press and hold the button
; release the button near the text ADV.
(DOWN-RADIO) until reaching
appears.
►
►
►
+3s
(5s)
(3s)
(3s)
(3s)
(MENU).
(MENU) button.
EN
►
13
Publicidad
