Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.5 - Radio remote control management
To save the buttons of a radio remote control, delete them or delete
all the saved radio remote controls, use the
access the
menu, press the
approximately two seconds; the wording
alternatively on the display.
NOTE: the control unit exits the
of inactivity or by briefly pressing the
4.5.1 - Memorisation of buttons of a radio remote control
1. Exit any menu, press and hold the button
2. Press and release the (DOWN-RADIO) button
activated: once for the STEP BY STEP output (
),three times for the ONLY OPEN output (
(
), 5 times for
= LIGHT ON/OFF).
NOTE: if the courtesy lights are activated by radio remote control, they will only be deactivated by radio
remote control.
3. Immediately after pressing the button
times corresponding to the selected function interspersed with a pause of approximately one second.
4. Near the control unit, within seven seconds press the button on the radio remote control to which to
associate the selected function; keep the radio remote control button pressed for a few seconds.
NOTE: for the pre-set function (5) press any button.
5. A long flash (approximately three seconds) of the KEY LED confirms correct storage.
!
WARNING
If the KEY LED emits a series of short flashes, the radio remote control button you
are trying to memorise is already present in the memory.
NOTE:after having memorise the radio remote control button, within seven seconds, it is possible to
associate another button of the same radio remote control or any button of another radio remote control,
to the same function, repeating the operations from point 3.
4.5.2 - Deletion of a memorised button of a radio remote control
Exit any menu, press and hold the button
.
1. Press and hold the button
2. Within seven seconds, press and hold the button of the radio remote control to be deleted from the
receiver's memory until the KEY LED starts flashing; release the button.
3. Confirm deletion of the radio remote control by pressing the button
4. A long flash of the KEY LED indicates that the radio remote control has been deleted.
5. The control unit exits the
(MENU)
If the transmitter you wish to delete was originally memorized using the
procedure mentioned above will delete all the functions associated with the buttons of that transmitter.
12
menu. To
(DOWN-RADIO) button for
appears
menu after seven seconds
(MENU) button.
(DOWN-RADIO) until the display shows, alternatively,
a number of times equal to the function to be
), twice for the PARTIAL output (
), 4 times for the LIGHT ON/OFF output
(key 1= SBS, key 2 = PARTIAL, key 3 = ONLY OPEN, key 4
(DOWN-RADIO), the KEY LED briefly flashes a number of
(DOWN-RADIO) until the display shows alternatively,
(DOWN-RADIO) until the KEY LED lights up; release the button.
after seven seconds of inactivity or by briefly pressing the button
NOTE: to facilitate saving operations, thereby minimising
any interference, it is advisable to disconnect the receiver's
antenna wire; therefore, the procedure only works near the control
panel itself.
!
WARNING
Once the operations have been completed,
reconnect the antenna wire to the control panel receiver.
(DOWN-RADIO)
output (see paragraph 4.5.1, point 2), the deletion
►
+
+
+1s
+1s
2 s
>3s
►
(3s)
►
3s
Publicidad
