Publicidad
Idiomas disponibles
Idiomas disponibles
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the
ON/OFF (1) button, when the hob
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
Model 603
To set the Power Limitation:
• press
(which will flash, only for the first 2 minutes
after the product has been switched on)
• while keeping
held down, press, one at a time, all
the Selection/Display areas (2) of the cooking zones, in
this sequence, (RL-2 -> CR-2 -> FL-2) as shown in the
figure:
At this point, the Display (CR-2) will show the symbols
and
alternately and the Display (FL-2) will show the
symbol
• select the Display (CR-2), the Selection bar (3) will light
up; select the penultimate vertical line on this bar. Now, the
Display (CR-2) will show the symbols
alternately.
At this point, it will be possible to change the absorption
value of the hob: select the Display (FL-2) and the
Selection bar (3) will light up again; select one of the three
available positions on this bar; according to this choice, the
Display (FL-2) will show a value between
The following table relates the displayed value to the
maximum absorption of the Hob:
Displayed value
Power (Kw)
7.2 Kw (default setting)
4.5 Kw
3.1 Kw
To save the selection made, press the ON/OFF (1) key for
2 seconds; an extended audible signal will be emitted to
confirm the setting.
Model 604-604P
To set the Power Limitation:
• press
after the product has been switched on)
• while keeping
the Selection/Display areas (2) of the cooking zones, in
this sequence, (FL-2 -> FR-2 -> RR-2 -> RL-2) as shown in
the figure:
At this point, the Display (RR-2) will show the symbols
and
symbol
• select the Display (RR-2), the Selection bar (3) will light
up; select the penultimate vertical line on this bar. Now, the
Display (RR-2) will show the symbols
alternately.
At this point, it will be possible to change the absorption
value of the hob: Select the Display (RL-2) and the
Selection bar (3) will light up again; select one of the three
available positions on this bar; according to this choice, the
and
Display (RL-2) will show a value between
The following table relates the displayed value to the
maximum absorption of the Hob:
Displayed value
and
.
To save the selection made, press the ON/OFF (1) key for
2 seconds; an extended audible signal will be emitted to
confirm the setting.
17
(which will flash, only for the first 2 minutes
held down, press, one at a time, all
alternately and the Display (RL-2) will show the
.
Power (Kw)
7.2 Kw (default setting)
4.5 Kw
3.1 Kw
and
and
.
Publicidad
