Publicidad
Idiomas disponibles
Idiomas disponibles
NO-MAR PAD (FIG. 4)
WARNING
removing or replacing the no-mar pad.
Failure to do so could result in serious personal
injury.
The no-mar pad attached to the nose of the
tool helps prevent marring and denting the work
surface when working with softer woods.
The no-mar pad can be removed by pulling it
down and away from the workpiece contact. To
replace the no-mar pad, fit it into place over the
workpiece contact and push up at the back to
reseat.
On-board storage for the no-mar pad is located
on the magazine of the tool. Two spare no-mar
pads are provided in the on-board storage area.
TO LOAD OR REMOVE NAILS (FIG. 5A & 5B)
WARNING
loading or removing nails. Failure to do so
could result in serious personal injury.
WARNING
others when loading nails. Failure to do so
could result in possible serious personal injury.
WARNING
this tool. The use of any other nails can result
in tool malfunction, leading to serious injuries.
WARNING
activated. Doing so could result in possible
serious personal injury.
To Load Nails:
a. Remove the battery pack from the tool.
b. With the nose of the tool pointed away from
you or other person, insert the nails into the
slot at the end of the magazine and push the
nails forward.
c. Press and hold the pusher release lever and
slide the magazine pusher back past the end
of the nails.
d. Continue to hold the magazine pusher, but
release the pusher release lever. Slowly slide
the pusher forward until it rests against the nails.
e. Reattach the battery pack, and reactivate
the nailer by pressing and holding the power
switch for 1 second.
Remove the battery pack
from the tool before
Remove the battery pack
from the tool before
Keep the tool pointed
away from yourself and
Use only the nails
recommended for use with
Never load nails with the
workpiece contact or trigger
Fig. 4
On-board
Storage
Fig. 5a
Fig. 5b
Nail Indicator Windows
You can observe the number of remaining nails
through the nail indicator windows, and load
more nails as needed.
Do not let the magazine pusher
NOTICE
snap back without guiding it. This
could damage the magazine pusher and there
is a risk of getting your fingers caught.
To Remove Nails:
a. Remove the battery pack from the tool.
b. Press and hold the pusher release lever and
slowly slide the pusher to the front of the
magazine.
c. Release the lever and remove the nails.
-12-
No-mar Pad
Slot
Magazine Pusher
Pusher
Release Lever
Publicidad
