Publicidad
Idiomas disponibles
Idiomas disponibles
Place the base pan into the cabinet opening, pushing it
4.
back until the front edge of the base pan rests against
the front edge of the cabinet bottom. Use the triangular
punch holes to align the base pan with the center line
on the cabinet bottom.
Mark 6 holes for the fixing screws.
5.
Remove the base pan from the cabinet and drill 6 holes
6.
at the marked locations using a ¹⁄₁₆" (1.6 mm) drill bit.
Place the base pan back into the cabinet opening, align
7.
it as before and secure it with 3 wood screws.
Secure the trim kit brackets at the top and bottom of the
8.
cabinet opening with 3 wood screws each.
Measure the height of the cabinet cutout. If the cutout
‒
is higher than 19⅞" (505 mm) attach the gap sheets
(K) to the upper trim kit bracket. 1 gap sheet adds
¹⁄₃₂" (1 mm).
Top of cabinet opening: Measure and mark the
‒
center of the cabinet opening and align it with the
center mark on the trim kit bracket. Align the trim kit
bracket with the front edge of the cabinet opening.
The flanges of the trim kit bracket must point toward
the front and downwards.
Bottom of cabinet opening: Align the trim kit
‒
bracket with the front edge of the base pan. The
flanges of the trim kit bracket must point toward the
front and upwards. The bore holes in the trim kit
bracket and the base pan must match.
6.2 Installing the appliance
WARNING
Before installing the appliance and trim kit, turn power
OFF at the service panel.
Lock the service panel to prevent the power from being
▶
turned ON accidentally.
Ensure the appliance cavity is empty.
1.
Use 2 people to turn the appliance over to access the
2.
bottom.
Note: Rest the appliance on the packaging material to
avoid damage to the appliance and kitchen surfaces.
Installation procedure en-us
11
Publicidad
