Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Installation procedure
Attach the microwave support brackets to the bottom of
3.
the appliance with 2 sheet metal screws on each side.
The arrows on the microwave support brackets must
point towards the front of the appliance.
Turn the appliance over and rest it at the front of the
4.
cabinet cutout.
Route the power cord to the power outlet and plug it in.
5.
Note: Make sure not to pinch the power cord while
pushing the microwave into the cabinet cutout during
the following steps.
Slide the appliance into the cabinet by inserting the
6.
microwave support brackets over the guides at the front
of the base pan.
The microwave support brackets must be flush with
‒
the front edge of the base pan.
12
Secure the microwave support brackets to the base pan
7.
with 2 sheet metal screws through the inside of the
microwave support brackets.
6.3 Installing the trim kit frame
Place the trim kit frame over the appliance front. The
1.
bore holes in the trim kit frame must align with the bore
holes in the installation brackets.
Check the printing on the back of the trim kit frame to
see which side goes up.
Insert the 4 adjustment shims between the trim kit frame
2.
and the appliance. The thinner edge of the adjustment
shims will fit in the gap at the top or bottom.
Adjustment
Position
shim type
Top right
¡
Bottom left
¡
Top left
¡
Bottom right
¡
Check if the appliance face and the trim kit frame face
3.
are flush and level.
If adjustment is necessary:
4.
Remove the adjustment shims.
‒
Publicidad
