Specifications - Sony MHC-G99AV Manual De Instrucciones

Notes on CD
•Do not use solvents such as benzene,
thinner, commercially available cleaners,
or antistatic spray intended for vinyl LPs.
•If there is a scratch, dirt or fingerprints on
the CD, these may cause a tracking error.

Specifications

CD player section
System Compact disc and digital
audio system
Laser Semiconductor laser
(λ = 780 nm)
Emission duration:
continuous
Laser output Max. 44.6 µW*
* This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
Wavelength 780 – 790 nm
Frequency response
2 Hz – 20 kHz (±0.5 dB)
Signal-to-noise ratio
More than 90 dB
Dynamic range More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength 600 nm
Output Level –18 dBm
Tuner section
FM stereo, FM/AM superheterodyne
tuner
FM tuner section
Tuning range 87.5 – 108.0 MHz
Antenna FM lead antenna
Antenna terminals
75 ohm unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
For Latin-American and Australian
models:
AM: 531 – 1,602 kHz (with
the tuning interval set at
9 kHz) 530 – 1,710 kHz
(with the tuning interval set
at 10 kHz)
For other models:
MW: 531 – 1,602 kHz (with
the interval set at 9 kHz)
530 – 1,710 kHz (with the
interval set at 10 kHz)
SW: 5.95 – 17.90 MHz
Antenna AM loop antenna,
External antenna terminals
Intermediate frequency
450 kHz
Amplifier section
Peak music power output
1,200 W
Continuous RMS power output
Front speakers:
80 W + 80 W (8 ohms at
1 kHz, 5% THD)
Rear speakers:
10 W + 10 W (16 ohms at
1 kHz, 5% THD)
Center speaker:
25 W (8 ohms at 1 kHz, 5%
THD)
Inputs
VIDEO/MD IN (phono jacks):
voltage 250 mV,
impedance 47 kilohms
MIX MIC (phone jack):
sensitivity 1 mV,
impedance 10 kilohms
Outputs
VIDEO/MD OUT (phono jacks):
voltage 250 mV
impedance 1 kilohms
PHONES (stereo phone jack):
accepts headphones of
8 ohms or more.
FRONT SPEAKER:
accepts impedance of 8 to
16 ohms.
REAR SPEAKER:
accepts impedance of
16 ohms.
CENTER SPEAKER:
accepts impedance of 8 to
16 ohms.
SUPER WOOFER:
Voltage 250 mV, impedance
1 kilo ohms
Tape player section
Recording system
4-track 2-channel stereo
Frequency response
(DOLBY NR OFF)
40 – 13,000 Hz ( ±3 dB),
using Sony TYPE I cassette
40 – 14,000 Hz ( ±3 dB),
using Sony TYPE II cassette
Wow and flutter
±0.15% W. Peak (IEC)
0.1% W. RMS (NAB)
±0.2% W. Peak (DIN)
Speaker section
Front speaker (SS-H991)
Speaker system 3-way speaker system
Magnetically shielded type
Speaker units Woofer: 17 cm, cone type
Tweeter: 5 cm, cone type
Super tweeter: 2 cm, dome
type
Enclosure type Bass-reflex
Rated impedance
8 ohms
Approx. 220 × 325 ×
Dimensions
275 mm (w/h/d) incl. front
grille
Mass Approx. 5 kg per speaker
Center speaker (SS-CN991)
Speaker system
Full range speaker system
Magnetically shielded type
Speaker unit 10 cm, cone type
Enclosure type Bass reflex
Rated impedance
8 ohms
Dimensions Approx. 280 x 110 x
175 mm (w/h/d) incl. front
grille
Mass Approx. 1.5 kg
Rear speaker (SS-SR991)
Speaker system
Full range speaker system
Magnetically shielded type
Speaker unit 10 cm, cone type
Enclosure type Bass reflex
Rated impedance
16 ohms
Dimensions Approx. 200 x 90 x 235 mm
(w/h/d)
incl. front grille
Mass Approx. 1 kg per speaker
Supplied accessories
AM loop antenna (1)
Remote RM-SE1AV (1)
Sony SUM-3 (NS) batteries (2)
FM lead antenna (1)
Speaker cords (5)
Foot (4)
General
Power requirements
Malaysian model:
220 – 240 V AC, 50/60 Hz
Australian model:
240 V AC, 50/60 Hz
Mexican model:
120 V AC, 60 Hz
Other models:
110 – 120 V or 220 – 240 V
AC, 50/60 Hz
Adjustable with the voltage
selector
Power consumption
190 W
Approx. 280 × 325 ×
Dimensions
360 mm (w/h/d)
incl. projecting parts and
controls
Mass Approx. 10.4 kg
Design and specifications are subject to
change without notice.
For Your Information
EN
31