Descargar Imprimir esta página

Tunturi PERFORMANCE T50 Manual Del Usuario página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 75
Profile programming mode�
- Press "Prog" button and select U-1/ U-2 or U-3.
- Press "Mode" button to open programming mode for the selected
User program.
- Profile programming menu will open in where you can set the
values for speed and incline the first out of 16 segments.
- You set your values by:
- Use "Speed + & -" Keys to set your desired speed setting.
- Use "Incline + & -" Keys to set your desired incline setting.
- Confirm by pressing "Mode" button.
- Programming mode for program profile segment 2 opens.
- The programming for the remaining 15 segments need to be done
in the same manner until all 16 segments are set.
- When confirming the 16th segment, the time window will blink to
set the desired training time.
- You set your desired workout time by:
Use "Speed + & -" keys to set your desired workout time.
Default setting: 30:00 min. / Setting range: 5:00~99:00 ± 1:00.
- Press the "Start/ Pause" button to start the program.
NOTE
• Programmed user program will be saved automatically so they
can be used next time.
Body Fat
The Body Fat program is to indicate your fiscal state based on your
body parameters and heart rate.
- Press "Mode" button to open programming mode.
- Press "Prog" buttons to select "8-1"
program, press "Mode" button to confirm.
- The display shows "F1" (SEX).
The display shows "1"
Press "Speed + & -" buttons to select:
1: Male/ 2: Female press "Mode" button to confirm.
- The display shows "F2" (Age). The display shows "25"
Press "Speed + & -" buttons to select:1~99
press "Mode" button to confirm.
- The display shows "F3" (Heigth). The display shows "170"cm
Press "Speed + & -" buttons to select:100~220 cm
press "Mode" button to confirm.
- The display shows "F4" (Weigth). The display shows "70"kg
Press "Speed + & -" buttons to select: 20~150 kg
press "Mode" button to confirm.
- The display shows "F5" (Active)
Hold the hand grip pulse measurement pads to activate the "FAT"
measurement.
In about 5~10 seconds the result will be shown. See "Result
calculation".
CAUTION
• Holding the contact hand-grip heart rate measurement pads is
required for this function.
Result calculation:
- BODY TYPE: ( Body Fat ratio; 4 types)
Body fat percentage
Body fat percentage
Body fat percentage
Body fat percentage
- BF = Body Fat ( in ratio % )
- Error code "ER" will show if no heart rate was detected during the
BF measurement process.
- Press "Stop/ Reset" button to leave Body Fat program.
HRC Program
The HRC program is a speed controlled program based on your heart
rate. The speed will automatically increase when your heart rate is
under target, and decrease when over target.
- Press "Prog" buttons to select "HRC"
HRC1: Pre-set maximum. Speed limit is 8 km/h.
HRC2: Pre-set maximum. Speed limit is 12 km/h.
HRC3: Pre-set maximum. Speed limit is 16.0 km/h.
Program.
- Set your age the display shows "25"
Press "Up/ Down" buttons to select:1~99
press "Mode" button to confirm.
- Target heartrate will be show, based on your set age. Target heart
rate = (220-age) x0,6.
Press "Up/ Down" buttons to change target value 60~200) press
"Mode" button to confirm.
- Set your workout time the display shows "30:00"
Press "Up/ Down" buttons to select: 5:00~99:00.
- Press the "Start/ Pause" button to start the program.
HRC operating function:
- HRC programs starts with a one minute warm up time. ( speed will
not auto adjust )
- The initial speed is 1.0 km/h, this can be adjust to a comfortable
warm up speed manually.
- Console checks heart rate every 30 seconds and controls the speed
as below.
Heart rate
parameter
29+ BPM
Under target
6~29 BPM
Under target
0~5 BPM
Under target
0~5 BPM
Over target
6~29 BPM
Over target
29+ BPM
Over target
NOTE
• Incline setting is not controlled in HRC program mode but
can be controlled by user at any time to intensify or ease your
workout.
• Speed can be changed by user at all times.
• When speed is over the pre set speed limit it will auto adjust to
pre set speed setting automatically.
• If no heart rate is detected, the treadmill will stop workout.
CAUTION
• Heart rate measurement is required for this function.
2 3
English
0 ~17
Underweight
18 ~ 24
Standard
25 ~ 28
Overweight
29 ~ +
Obesity.
speed adjust
+ 2.0 Km/h
+ 1.0 Km/h
No adjust
No adjust
- 1.0 Km/h
- 2.0 Km/h

Publicidad

loading

Este manual también es adecuado para:

22trn50000