Endress+Hauser iTEMP TMT162 Manual De Instrucciones página 67

iTEMP TMT162
Expert → Sensor →
Expert → Sensor →
1) n = número de entradas de sensor (1 y 2)
Expert → Sensor →
Expert → Sensor →
1) n = número de entradas de sensor (1 y 2)
Expert → Sensor →
Expert → Output →
Endress+Hauser
Menú de configuración y descripción de los parámetros
Canales de medición
1)
Sensor n → Sensor type n
Connection type n
2-wire compensation n
Reference junction n
RJ preset value n
Sensor offset n
Sensor serial number
Sensor n → Sensor trimming →
1)
Sensor n → Linearization →
Drift/calibration → Sensor switch set point
Drift/difference mode
Drift/difference alarm delay
Drift/difference set point
Control
Start value
Calibration countdown
4mA value
20mA value
Failure mode
Failure current
4 mA current trimming
20 mA current trimming
Reset trim
→  95
→  74
→  74
→  74
→  75
→  75
→  75
→  97
Sensor trimming →  98
Sensor trimming lower →  98
value
Sensor trimming upper →  98
value
Sensor trimming min span →  99
Reset trim →  99
Call./v. Dusen coeff. R0, A, →  99
B, C
Polynomial coeff. R0, A, B →  100
Sensor n lower limit
Sensor n upper limit
→  79
→  78
→  78
→  79
→  102
→  102
→  102
→  73
→  73
→  80
→  81
→  81
→  81
→  81
67