Silverline 421042 Manual Del Usuario página 7

Switching 'ON/OFF'
WARNING: Always wear safety goggles, an adequate dust mask, hearing protection and suitable
gloves, when working with this tool.
WARNING: NEVER touch the Sanding Sheet when the tool is switched ON
Note: Always use clamps to secure your workpiece to the workbench wherever possible.
• Always grip the sander firmly using the Palm Grip (1)
• Press I on the ON/OFF Switch (6) to switch the sander ON
• Press 0 on the ON/OFF Switch to switch the sander OFF
Sanding tips
• Do not bring the sander into contact with the workpiece until the motor has gained full speed.
Remove the sander from the workpiece before switching the tool OFF.
• Start with a coarse grit paper, and work through progressively to finer grit papers until the
desired finish is achieved.
• Only apply moderate pressure to the sander. Pressing too hard onto the work surface may
overheat the motor or damage the workpiece.
• Sand evenly over the work surface as the machine works in an orbital motion it is not necessary
to work with the grain.
• Only use the sander 'flat on' to the workpiece. Tilting the sander onto its edge will damage your
workpiece.
WARNING: Do not allow the sandpaper to completely wear down before replacing it. Failure to
observe these precautionary measures can lead to damage to the base of the tool.
Accessories
• A full range of accessories including sanding sheets, is available from your Silverline stockist.
• Spare parts can be purchased from your Silverline dealer or online at www.toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the mains power supply, before carrying out any
maintenance/cleaning.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time.
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the tool's service life. Clean the body of your tool with a soft brush, or dry cloth. If
available, use clean, dry, compressed air to blow through the ventilation holes.
Storage
• Store this tool carefully in a secure, dry place out of the reach of children.
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222.
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste.
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools.
silverlinetools.com
Detail Sander
EN 7