Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Troubleshooting
Problem
Possible Cause
Solution
No power
Check power supply
No function when ON/OFF
Switch (6) is operated
Defective ON/OFF Switch
Have the ON/OFF Switch replaced by an authorised Silverline service centre
Slow material removal
Sanding sheet too fine or worn
Fit new sanding sheet with coarser grit
Sanding sheet too coarse
Fit new sanding sheet with finer grit
Scratches on workpiece
after sanding
Not enough material removed
Continue sanding
Sanding sheet incompatible with material
Fit correct sanding sheet
Burn marks on workpiece
Too much pressure exerted on to the sander
Use less pressure whilst using the machine
Dust extraction not working; sanding sheet
Excessive dust emission
not aligned with dust extraction holes in the
Realign sanding sheet; unblock dust extraction holes
Sanding Base Plate (4); extraction holes blocked
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8
Publicidad
