AXXAIR DC65-MA1 Manual De Instrucciones página 38

INNOVATIVE ORBITAL SOLUTIONS

Dismount and take out the tool holder plate by unscrewing the screw
IDIN7984 M5x20 (3.0 mm Allen key)

Firstly, install the HSS plate on the tool holder. Then install and tighten the plate screw
(tightening torque = 2.55 Nm, Torx T15 screwdriver supplied).

Then, install the tool holder on the tool holder plate
NOTE 1: Position the tool holder according to the outer diameter of the processed tube. There
is a range from 0 to 60mm/2,362" to cover the diameters range.
NOTE 2: To facilitate tool holder mounting, apply a little high-temperature grease, such as
"ELECTROLUBE HTG - HTG50T", to the tool holder locking screw, every time the machine is
serviced
Join experience
Plate screw
(rep1)
Grease on locking
screw
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Original Instruction - ENGLISH
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - commerce@axxair.com - www.axxair.com
- 38 -