Publicidad
Idiomas disponibles
Idiomas disponibles
PREVENTING SNAGGING
Snagging occurs when polishing pads get caught on rough edges of a work surface.
Snagging can cause the tool suddenly "kick back" and it may cause the pad to burn
through the paint. To reduce the risk of snagging, use the polisher at low speeds when
polishing rough surfaces. For tricky areas such as near trim or between a mirror and
window on a car, do not take chances with a polisher. Polish these surfaces by hand.
WARNING INDICATOR
After starting the polisher, the Power ON green light is on.
The red light is on to warn: the polisher is abnormal, or the protection is activated:
Protection
The battery is over temp./low temp.
The polisher is overheated
WARNING
Remove the battery pack from this tool before cleaning solutions.
NOTE
This tool is lubricated before it leaves the factory. This lubrication should last for the life of
the tool. No further lubrication is required.
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this. Exterior plastic parts may be
cleaned a damp cloth and mild detergent. Although these parts are highly are solvent
resistant, NEVER use solvent.
CHARGER CLEANING INSTRUCTIONS
Dirt and grease may be removed from the exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any cleaning solutions.
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Recommended accessories for use with your tool are available at extra cost from your
local service center.
1English1
Warning light
The red light is on
The red light is flashing
MAINTENANCE
ACCESSORIES
English
-12
Troubleshooting
Replace the battery
Cool the polisher
Publicidad
