Publicidad
Idiomas disponibles
Idiomas disponibles
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Never service damaged BATTERY packs. Service of BATTERY packs should
only be performed by the manufacturer or authorized service providers.
Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel may result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions
in the Maintenance section of this manual. Use of unauthorized parts or failure to
follow Maintenance Instructions may create a risk of shock or injury.
SPECIFIC SAFETY RULES AND SYMBOLS
CAUTION
a.
Do not operate this tool for long periods of time. Vibration caused by the operating action of this
tool may cause permanent injury to fingers, hands, and arms. Use gloves to provide extra cushion,
take frequent rest periods, and limit daily time of use.
This power tool is intended to function as a polisher. Read all safety warnings, instructions,
b.
illustrations and specifications provided with this power tool. Failure to follow all instructions
listed in this manual may result in electric shock, fire and serious injury.
c.
Do not use accessories which are not specifically designed and recommended by the tool
manufacturer. Just because the accessory can be attached to your power tool, it does not assure
safe operation.
d.
The rated speed of the accessory must be at least equal to the maximum speed marked on the
power tool. Accessories running faster than their rated speed can fly apart.
e.
The outside diameter and the thickness of your accessory must be within the capacity rating
of your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled.
f.
Threaded mounting of accessories must match the Polisher spindle thread. For accessories
mounted by flanges, the arbour hole of the accessory must fit the locating diameter of the
flange. Accessories that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
g.
Do not use a damaged accessory. Before each use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose
or cracked wires. If power tool or accessory is dropped, inspect for damage or install an
undamaged accessory. After inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and run the power tool at
maximum no load speed for one minute. Damaged accessories will normally break apart during
this test time.
Wear personal protective equipment. Depending on application, use face shield, safety
h.
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and
shop apron capable of stopping small abrasive or workpiece fragments. The eye protection
must be capable of stopping flying debris generated by various operations. The dust mask or
respirator must be capable of filtrating particles generated by your operation. Prolonged exposure
to high intensity noise may cause hearing loss.
Keep bystanders safe distance away from work area. Anyone entering the work area must
i.
wear personal protective equipment. Fragments of workpiece or of a broken accessory may fly
away and cause injury beyond immediate area of operation.
1English1
SERVICE
English
-5
Publicidad
