Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
FREEDOM
PLUS Cordless Robotic Cleaner | Owner's Manual
®
™
On periodic SMART Cycle cleaning, the app will
count down from the optimized cleaning time.
NOTE: To Recalculate SMART Cycle, go to the Set
Cleaning Mode after the initial calculation.
5.3
In-App Error Messages and
Troubleshooting
After removal and when connected to WiFi, the app
will display any errors from the previous cleaning
cycle.
1.
Click on the warning symbol to view
troubleshooting advice on how to fix the issue.
2.
Choose Clear Error if you believe you have
fixed the problem and want to re-try. Choose
OK if you want to suspend the cleaner in error
mode and work on the troubleshooting fix at a
later time.
5.4
System Settings
Access System Settings by pressing the gear icon
in the upper right hand corner of the app screen.
Section 6. Maintenance
WARNING
To avoid electric shock and other hazards which could result in
permanent injury or death, disconnect (unplug) the cleaner from the
power source before performing any cleaning and maintenance.
Figure 18. Charging Caddy Distance to Pool Edge
6.1
Clean the Cleaner and Charging
Caddy
1.
Always dry the cleaner before setting on the
charging caddy.
2.
Clean the charge plates ON the charging
station using a cloth or scouring pad. DO NOT
use metal sponges or brushes and solvents or
salt water.
11.5 ft
(3.5 m)
Figure 19. Clean the Charge Plates
3.
Clean the charge plates UNDER the cleaner
using a cloth or scouring pad. DO NOT use
metal sponges or brushes and solvents or
salt water.
4.
Rinse the cleaner and charging caddy
thoroughly with clean water.
5.
Dry the cleaner and charging caddy with a
towel. DO NOT leave the cleaner and charging
caddy to dry in the direct sun.
6.2
Clean the Filter Canisters
The filter canisters should be cleaned at the end of
each cycle before debris dries.
1.
Push the cover lock and lift the cover until it is
secured in the vertical position.
Figure 20. Lift Cleaner Cover
2.
Remove the filter canister assembly from the
body.
3.
Empty all debris from the filter canisters, then
rinse the filters and the cleaner using a hose.
Page 13
Publicidad
