Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
FREEDOM
PLUS Cordless Robotic Cleaner | Owner's Manual
®
™
3.6
Start Cleaner
1.
Select Cleaning Mode using the slider by
sliding and releasing to the left or by using
the App.
Cleaning Mode
Floor/Wall
Product or App
Floor
Product or App
SMART
Waterline
Figure 6.
Slide and Release Left to Select Mode
NOTE: Choose Floor Only mode to clean with Pool
Cover on.
2.
Start the cleaner using the slider by sliding and
releasing to the right or use the App.
Figure 7.
Slide and Release Right to Start
3.
The cleaner does not begin moving until it
senses water. A blinking blue LED light means
it is ready to clean.
3.7
Submerge the Cleaner
1.
At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside.
Select
Runtime
2.5 hrs
1.5 hrs
In App
Calculated
In App
0:45 min
1
Figure 8.
Submerge the Cleaner Vertically
2.
Wait for bubbles to stop completely, then let
the cleaner sink to the bottom of the pool.
2
Figure 9.
Cleaner Sinking to the Bottom of the Pool
3.
Cleaning cycle will start as soon as the cleaner
detects the pool floor.
WARNING
Do not enter pool while the robotic cleaner is in water.
3.8
Remote Control
The LiFi remote control uses light signals to
communicate underwater with the cleaner. Use
the remote to start/stop a cleaning cycle, direct
the cleaner, or remove the cleaner from the pool.
Bright sunlight may interfere with the signal. Hold
tip of remote underwater pointing at the cleaner's
antenna to send a command. Maximum distance
between remote control and cleaner is 20 feet (7m).
The remote is water resistant up to 1 foot (30cm)
and floats if dropped in water.
Page 9
Publicidad
