Publicidad
Idiomas disponibles
Idiomas disponibles
3.3
Information/Status LEDs
Battery Status
Wi-Fi Connection Status
Operating Status
The Cleaner goes into deep sleep after 8 days of inactivity to protect the battery. When all indicators are
off, the cleaner is in sleep mode. Re-set the cleaner on the charging base to wake it up. If this does not
work, see troubleshooting.
3.4
Charging Caddy Status
Solid Green
Solid Red
Blinking Green
Figure 5.
Charging Caddy Status LED
Page 8
Solid Green
Blinking Green
Solid Orange
Blinking Orange
Blinking Red
Blinking Blue
Solid Blue
Blinking Blue
Blinking Red
Floor, walls, and waterline
(2 h 30 min)
Floor only (1 h 30 min)
Base is receiving power
Charging is in progress
Charging caddy needs
to be replaced
Polaris
FREEDOM
PLUS Cordless Robotic Cleaner | Owner's Manual
®
™
Fully charged.
Ready to run a full cycle (2 h 30 min).
Not fully charged. May not run a complete floor & wall
cycle.
Very low battery level. Charge required. Cannot run
cleaner.
Charging error. Cleaner is too hot.
Pairing.
Connected to Wi-Fi.
Out of Water: Ready to submerge, start cleaning.
In Water: End of cycle. Waiting for removal from pool.
Error. See app or troubleshooting.
Additional cleaning modes available in app. If app mode
chosen, both lights are illuminated.
3.5
Remote Control Status
Remote
Blinking
red blinking LED
NOTE: To replace batteries, use Phillips head
screwdriver to remove 6 screws and replace
batteries. Securely tighten screws after
replacement to ensure remote is watertight.
Possible
Solutions
Cause
Remote
Remove
Battery
battery cover
Power is
and replace
Low
both AA
batteries.
Publicidad
