cecotec BOLERO SQUAD 2001 Manual De Instrucciones página 63

Idiomas disponibles

install it on your own.

Do not install the induction hob directly over a dishwasher, a refrigerator, a freezer, a

washing machine or a dryer, as moisture could damage the electric system of the hob.

The induction hob must be installed in a manner that ensures the best heat radiation to

obtain the best results.

The wall and the area over the work surface must be heat resistant.

To avoid any damage and ensure a correct fixing of the hob, we recommend sealing the

latter using a sealing gasket or heat-resistant adhesive.

You should not use steam cleaners.

Connecting the hob to the mains

Fig. 9

The induction hob must be connected to the mains by a suitably qualified person.

Before connecting the hob to the mains, check that:

1. Your home wiring system is suitable for the power consumption of the cooking hob.

2. The mains voltage matches the voltage stated on the rating label of the appliance.

The power cord supplied with the hob is sized to withstand the specific load indicated on

the product label.

To connect the hob to the mains, do not use adapters, reducers, or branching devices, as

they may cause overheating or fire.

The power cord should not be in contact with any hot parts and must be positioned so as

to avoid its temperature exceeding 75°C.

Warning

Check with an electrician whether your home wiring system is suitable without modifying

it.

Any modifications should only be carried out by a qualified electrician.

The power supply must be connected in accordance with the relevant regulations. The

connection method is shown in Figure 9.

If the cord of the induction hob is damaged, it must be replaced by the manufacturer, the

supplier, or similarly qualified personnel to avoid a hazard.

If the appliance is connected directly to the mains, a single-pole residual current circuit

breaker with a minimum contact separation of 3 mm must be installed.

The person in charge of the installation must ensure that a correct electrical connection

has been made and that it complies with safety regulations.

Do not bend or press the cord.

Check the cord for damage regularly.

The yellow/green wire of the power cord must be earthed at the power supply terminals

and at the appliance.

The manufacturer is not liable for accidents resulting from the use of a non-earthed or

improperly earthed appliance.

ENGLISH

BOLERO SQUAD I 2001