cecotec BOLERO SQUAD 2001 Manual De Instrucciones página 73

The induction hob or a
cooking zone has turned
off unexpectedly, emits
a sound, and an error
code is displayed (usually
alternating with one or
two digits on the cooking
timer display).
Please note
- These instructions are intended for qualified technicians, do not attempt to carry them
out if you do not have the necessary training and knowledge, as any damage caused by an
incorrect repair will void the warranty.
Do not try to disassemble the unit on your own to avoid hazards and damages to the
-
induction hob.
Error codes and possible solutions
The induction hob is fitted with a self-diagnostic function. With this function, the technician
can check the operation of different components without de-installing the induction hob from
the worktop.
Error
Problem
code
Board sensor failure (open
E1
circuit).
Board sensor failure (short
E2
circuit).
Failure of the ceramic-glass
E7
sensor.
High temperature of the hob
C1
sensor.
IGBT transistor temperature
E3
sensor failure (open circuit).
IGBT transistor temperature
E4
sensor failure (short circuit).
Technical fault. Write down the error letters
and numbers, unplug the
induction hob from the mains,
and contact the official Cecotec
Customer Service.
Possible solutions
Contact the official Technical Support Service
of Cecotec.
Wait for the sensor to return to normal
operating temperature.
Press the Power button.
Contact the official Technical Support Service
of Cecotec.
ENGLISH
BOLERO SQUAD I 2001
73