cecotec BOLERO SQUAD 2001 Manual De Instrucciones página 65

cookware and the cooking-zone surface are clean and dry.
3. When pressing the cooking-zone selection button, the indicator next to the button will
flash.
4. Adjust the power by pressing the + and/or – buttons.
If power is not selected within 1 minute, the hob will turn off automatically. You must turn
-
it on again and retry from step 1.
You can change the power any time while cooking.
-
and the power setting alternately flash on the display
This can mean:
You have not placed the cookware in the correct cooking zone.
-
The cookware you are using is not suitable for the induction hob.
-
The cookware is too small or is not correctly centred on the cooking zone.
-
If you do not place suitable cookware on the cooking zone, the latter will not heat up.
The display will turn off automatically after 2 minutes if you do not place any cookware.
Finish cooking
Fig. 16
1. Press the cooking-zone selection button of the cooking zone you wish to turn off.
2. To turn off the cooking zone, press – until the value is 0 or press the + and – buttons
simultaneously. Make sure the display shows 0.
3. Turn off the hob completely by pressing the power button.
Caution with hot surfaces
Fig. 17
The hob will show H for any cooking zone that is still hot to the touch after use. The H will
disappear when the surface has cooled down and reached a safe temperature. You can also
use a hot hob to save energy if you wish to heat more frying pans.
Buttons lock
You can lock the buttons to avoid any unintentional use (e.g., children accidentally turning
-
on the cooking zones).
When the lock is active, all buttons will be disabled except the power button, so you can
-
turn off the hob with this button in case of emergency, but you should unlock all buttons
when you turn the hob back on.
Locking the buttons
Press the Timer button and the Boost Mode button simultaneously: the timer indicator will
display "Lo".
ENGLISH
BOLERO SQUAD I 2001
65