Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Washing and storage
WASHING THE BIKE
SHERCO advises you to wash your 125
SE/R as often as possible in order to
maintain it in good working order
and prolong its life.
1. Cover the end of the exhaust silencer and
the air filter (plastic bag, special cover
or a special cap).
2. To degrease the engine, apply
a degreaser, clean with a brush then rinse
the engine with a water hose.
3. Wash the rest of the vehicle with hot
soapy water.
4. Rinse with clear water.
5. Dry with a chamois or a clean, soft cloth.
6. Clean the chain and lubricate it with
a special chain lube.
7. When the cleaning is finished, remove the
air filter and exhaust protection, start the
engine and let it run atidle for a few minu-
tes.
Avoid using high pressure equipment which
may cause water to leak into the bearings
and fork seals and cause serious damage.
Use an average strength detergent rather
than a strong detergent.
CAUTION
In order to avoid any water ingress, keep a mini-
mal washing distance of 20cm.
STORING THE BIKE
Before storing the vehicle Long-Term (more
than 2 months), follow these instructions :
1. Wash the whole bike.
2. Empty the fuel tank.
3. Remove the spark plug and inject
a protective spray inside the engine
through the hole in the cylinder. Install the
spark plug. Cycle the engine a few revolu-
tions to apply a protective film on the
cylinder walls.
4. Remove the battery (
5. Charge the battery (
6. Lubricate all cables with a spray lubricant.
7. Jack the motorcycle up so that the wheels
are off the ground.
8. Cover the exhaust outlet with a plastic
bag to prevent moisture from entering.
9. Spray a protective oil film on all unpainted
metal surfaces of the motor and also on
the electrical wiring.
10. Cover the motorcycle with a cover.
RECOMMISSSIONING AFTER
STORAGE
Reinstall the battery (
Fill the fuel tank.
Perform lubrication and maintenance (
Perform a road test.
p.124)
☛
p.125)
☛
p.125)
☛
p.130)
☛
129
Publicidad
Capítulos
Tabla de contenido
