Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continue)
INSTALL FILTERS
•
Reassemble grease tray and hybrid filters into the hood.
ELECTRICAL CONNECTION
Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards.
•
Turn off electrical power at service entrance before wiring.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Do not use the plug and an extension cord other than the ones initially supplied with the hood.
•
The grounding of this hood is compulsory. Do not remove ground prong of the plug.
•
To a risk of fire, electric shock, or injury to persons, for cleaning and user-maintenance, such as lubrication to
unplug or disconnect the appliance from the power supply before servicing.
Operating Instruction
K1: POWER BUTTON
When the range hood is on, press K1 button to enter Power-Off Delay Timer, the Timer working time is 15 minutes,
the range hood will turn off when the time reach 0. If you push K1 button again, the range hood will turn off.
When the range hood is off, press and hold on K1 button for 3 seconds will enter the clock adjustment mode, press
K4 INCREASE BUTTON and K3 DECREASE BUTTON to adjust the hour, press K1 button again, you can adjust the
minutes, also press K4 INCREASE BUTTON and K3 DECREASE button to adjust minutes.
K2: LIGHT BUTTON
Press this button to turn on the light, once again, turn off light.
K3, K4: DECREASE BUTTON AND INCREASE BUTTON
Press these two buttons to adjust the speed when the range hood is on, to adjust the time when the range hood is in
clock mode.
Maintenance & Cleaning
Surface Maintenance:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent (e.g. comet
powder scrub, EZ-Off oven cleaner), or steel wool/scoring pads which will scratch and damage surface. For heavier
soil use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
After cleaning, you may use non abrasive stainless steel polish/cleaners such as 3M or ZEP, to polish and buff out the
stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
Stainless Steel Hybrid Filters:
The Filters fitted by the factory are intended to filter out residue and grease from cooking. It need not be replaced on a
regular basis but are required to be kept clean.
Filters should be cleaned after every 30 hours of use.
Remove and clean by hand in a basin of hot soapy water. The filter is also dishwasher safe. If heavily soiled, spray
'Formula 409' or equivalent degreasing detergent and leave to soak.
Dry filters and re-install before using hood.
K4
K3
K2
14
K1
Publicidad
