Maintenance & Cleaning (continue)
OIL CUP
The oil cup should be cleaned often according to the amount of oil in the cup.
Clean oil cup by hand in a basin of hot soapy water. If heavily soiled, spray "Formula 409" or equivalent degreasing
detergent and leave to soak. Slide oil cup out / in from the slot at the bottom of the block.
HOOD CLEANING
The saturation of greasy residue in the blower and filters may cause increased inflammability. Keep unit clean and
free of grease and residue build-up at all times to prevent possible fires.
Filters must be cleaned periodically and free from accumulation of cooking residue (see cleaning instructions
inside). Old and worn filters must be replaced immediately. Do not operate blowers when filters are removed. Never
disassemble parts to clean without proper instructions. Disassembly is recommended to be performed by qualified
personnel only. Call our service center for removal instructions.
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
•
Hot water with soap or detergent is all that is usually needed.
•
Rinse with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
•
For discolorations or deposits that persist, use a non-scratching household cleanser or stainless steel polishing
powder with a little amount of water and a soft cloth.
•
For stubborn stain, use a plastic scouring pad or soft bristle brush together with cleanser and water. Rub lightly
in direction of polishing lines or "grain" of the stainless finish. Avoid using too much pressure that may mar the
surface.
•
Do not allow deposits to remain for long periods of time.
•
Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing rust.
•
Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless
steel for extended periods. Many of these compounds contain chemicals that may be harmful. Rinse with water
after exposure and wipe dry with a clean cloth.
•
Painted surfaces should be cleaned with warm water and mild detergent only.
Oil Plate
15