Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance & Cleaning (continue)
Please ensure lights have been switched off for some time and the power source has been disconnected before
replacing any globes. Please be aware that the light will retain heat for a short period of time after being switched
off.
HOW TO REPLACE STRIPE LED LIGHT
Step 1: Remove light panel by removing screws in "H" location
Note: Please take extra care and make sure you do not damage the range hood
Step 2: Turn the three screws anti-clockwise in the back of LED light
Step 3: Remove the LED light through Connector
Replace new stripe LED with connector and install three screws clockwise, attach light panel to hood with screws in
the "H" location.
CAUTION: DO NOT TOUCH SURFACE UNITS OR AREAS NEAR UNITS – Surface units may be hot even
though they are dark in color. Areas near surface units may become hot enough to cause burns. During and after
use, do not touch, or let clothing or other flammable materials contact surface units or areas near units until they
have had sufficient time to cool. Among these areas are (identification of areas – for example, the cook-top and
surfaces facing the cook-top).
HOW TO INSTALL HEAT LIGHT
Place the light into the light holder, turn clockwise to tighten heat light. Turn the heat light counterclockwise to
disassemble.
WARNING
CAUTION-HOT SURFACE
3 Holes for LED strip installation
H
Connector
WARNING
CAUTION-HOT SURFACE Heating-lamp rated 120 VAC,220W
Disconnected from the source of supply before install the light
Heat lamp socket
Washer and wing bolt
for installation
16
H
Publicidad
