Publicidad
Idiomas disponibles
Idiomas disponibles
Range Hood Safety
1. TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
2. GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded.
WARNING
Improper grounding can result in a risk of electric shock. Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded. Do
not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near
the appliance.
CAUTION
- To reduce risk of fire and to properly exhaust air, be sure to duct air outside
- Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
NOTE: remove protective film (if any) from the exterior surfaces of the hood carefully prior to final installation.
DESCRIPTION / CONNECTION
This range hood should be mounted directly to the support frame mounting, where the support frame flue shall secure
to the ceiling joist or framework.
•
Ductwork can be installed vertically or horizontally.
•
Duct runs should be as short as possible.
•
Avoid the use of elbows.
•
Use duct tape at all joints.
•
Do not use duct smaller than the discharge on the hood.
LOCATION PREPARATION
The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified
background. DO NOT attempt to install this appliance yourself. Injury could result from installing the unit due to lack of
appropriate electrical and technical background.
All electrical wiring must be properly installed, insulated and grounded. Overly accumulated grease in old duct work
should be cleaned out or duct work should be replaced if necessary to avoid the possibility of a grease fire. Check all
joints on duct work to insure proper connection and all joints should be properly taped.
Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and
chimney prior to final installation.
Note 2 : At least two people will be required to mount the hood.
Clearance
MOUNT HEIGHTS & CLEARANCE:
Minimum mount height between range top to hood bottom should be no less than 25"
Maximum mount height should be no higher than 30"
It is important to install the hood at the proper mounting height. Hoods mounted too low
could result in heat damage and fire hazard; while hoods mounted too high will be hard to
reach and will loose its performance and efficiency.
If available, also refer range manufacturer's height clearance requirements and
recommended hood mounting height above range.
* Maximum ceiling clearance 106.5" at 27.5" hood mounting height from stove (different
models may varies)
** For higher ceiling, extension of the chimney and the decorative cover is available to
purchase, if require.
WARNING
7
Maximum
Ceiling Height
8 to 9ft
(special order
for higher
ceiling)
Clearance
between hood
and stove
25"-30"
Publicidad
