Festool ES 150/3 EQ Instrucciones De Servicio página 7

Technical data
Wattage
Speed
Power stroke
Sanding stroke
Sanding base
Weight
Degree of protection
The specified illustrations can be found at the beginning of the operating instructions.
1 Before using sander
1.1 Safety instructions
Read the safety instructions on the
attached sheet before using the sander.
Always wear protective goggles
because of possible dangers when
sanding.
The manufacturer’s handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to
occur during sanding.
The electric tool must be connected to a suitable
dust extraction unit and applicable safety
regulations must be observ ed if dusts
dangerous to health are likely to occur during
sanding.
Wear a dust mask for your own safety.
1.2 Correct usage
The sanders are designed for sanding wood,
plastic, composite materials, paint / varnish,
filling material and similar materials.
Metal and materials with an asbestos content
must not be processed with these tools.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
The user bears sole responsibility for any
damage or accidents resulting from incorrect
use.
1.3 Noise and vibration information
Typical values established in compliance with
EN 50 144:
Sound pressure level
Measured acceleration
ES 150/3 EQ
ES 150/5 EQ
The noise level can exceed 85 dB(A)
during work.
Wear ear protectors!
ES 150/3 EQ
310 W
4,000 - 10,500 rpm
8,000 - 21,000 rpm
3.0 mm
Æ 150 mm
1.8 kg
/ II
2
Switch (1.2) is an on/off switch.
For continuous use it can be engaged with the
lateral locking button (1.3). Pressing the switch
again releases the lock.
See Fig. 3 for connection and disconnection of
the power cable.
3
This allows the sanding speed to be adapted to
the optimum level according to the material
concerned. The speed is set using the rotary
control button (1.1).
The numbers on the rotary control button
represent approximately the following stroke/
orbit speeds:
70 dB(A)
4
4.0 m/s²
6.0 m/s²
4.1
The machines are fitted with inbuilt extraction
as standard.
7
ES 150/5 EQ
310 W
4,000 - 9,000 rpm
8,000 - 19,000 rpm
5.0 mm
Æ 150 mm
1.8 kg
/ II
Electrical connection and operation
The mains voltage
correspond with the voltage on the
rating plate!
Electronic control
The ES 150/3 EQ, ES 150/5 EQ has an
electronic control with which the
rotational speed can be varied step-
free.
Dust extraction
Dust extractors
accumulations of dust in the air in the
working environment and dirt collecting
in the workplace.
Inboard extraction
must
prevent large