Publicidad
Idiomas disponibles
Idiomas disponibles
Pans do not become
hot and
appears in
the display.
The induction hob or
a cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).
Never attempt to disassemble the unit by yourself.
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem
Possible causes
F3-F8
Temperature sensor failure
F9-FE
Temperature sensor of the
IGBT failure.
E1/E2
Abnormal supply voltage
E3/E4
Abnormal temperature
E5/E6
Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any danger and
damages to the induction hob.
The induction hob cannot
detect the pan because it is
not suitable for induction
cooking.
The induction hob cannot
detect the pan because it is
too small for the cooking zone
or not properly centred on it.
Technical fault.
Use cookware suitable for induction
cooking. See section „Choosing the
right cookware".
Centre the pan and make sure that
its base matches the size of the
cooking zone.
Please note down the error letters
and numbers, switch the power to
the induction hob off at the wall,
and contact a qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether
power supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
EN-17
Publicidad
