Publicidad
Idiomas disponibles
Idiomas disponibles
2. The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics.
3. The induction hotplate shall be installed such that better heat radiation can
be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
Connecting the hob to the mains power supply
This hob must be connected to the mains power supply only by a suitably
qualified person.
Before connecting the hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob
2. the voltage corresponds to the value given in the rating plate
3. the power supply cable sections can withstand the load specified on the rating
plate. To connect the hob to the mains power supply, do not use adapters, reducers,
or branching devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that
its temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable
without alterations. Any alterations must only be made by a qualified
electrician.
The power supply should be connected in compliance with the relevant
standard or a single-pole circuit breaker. The method of connection is shown
below.
EN-21
Publicidad
