Publicidad
Idiomas disponibles
Idiomas disponibles
STARTUP / SPRAYING TECHNIQUE
4.6
VENTILATE UNIT (HYDRAULIC SYSTEM) IF
UNIT FAILS TO PRIME
1. Switch the pump ON (Pos. I) using the ON/OFF switch (2).
2. Turn pressure control knob (3) approximately. three times
counter-clockwise.
3. Set pressure relief valve (1) to
hydraulic system is ventilated. Leave the pump running
for two to three minutes.
4. Then slowly turn pressure control knob (3) clockwise until
you can hear the sound of the inlet valve.
5. If not, repeat points 2 and 4.
4.7
GETTING READY TO SPRAY
UNIT WITH SUCTION TUBE
1. Immerse the suction system into a container filled with
coating material.
UNIT WITH OPTIONAL HOPPER
2. Fill coating material into the hopper.
3. Set pressure relief valve (1) to
4. Switch the pump ON (Pos. I) using the ON/OFF switch (2).
5. Slowly turn the pressure control knob (3) clockwise.
When the noise of the valves changes, the unit is bled
and takes in coating material.
6. If coating material exits from the return hose, turn the
pressure control knob (3) back approx. 1 rotation.
7. Set
pressure
relief
Pressure will increase inside the high pressure hose.
8. Pull the trigger of the spray gun and spray into an open
and empty container in order to remove the remaining
cleaning agent from the unit. When coating materials exits
from the tip, close the spray gun.
9. Adjust the spraying pressure by turning the pressure
control knob (3).
10. The unit is ready to spray.
12
(circulation). The
( circulation).
valve
(1)
to
(spray).
5
SPRAYING TECHNIQUE
Injection hazard. Do not spray without the tip
guard in place. NEVER trigger the gun unless the
tip is completely turned to either the spray or the
unclog position. ALWAYS engage the gun trigger
lock before removing, replacing or cleaning tip.
A) The key to a good paint job is an even coating over the
entire surface. Keep your arm moving at a constant
speed and keep the spray gun at a constant distance from
the surface. The best spraying distance is 10-12 inches
(25 to 30 cm) between the spray tip and the surface.
A
B) Keep the spray gun at right angles to the surface. This
means moving your entire arm back and forth rather than
just flexing your wrist.
Keep the spray gun perpendicular to the surface,
otherwise one end of the pattern will be thicker than the
other.
B
C) Trigger gun after starting the stroke. Release the trigger
before ending the stroke. The spray gun should be
moving when the trigger is pulled and released. Overlap
each stroke by about 30%. This will ensure an even
coating.
ELITE 2000
25 - 30 cm
Publicidad
