Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE UNIT
8.3
HIGH-PRESSURE FILTER (OPTIONAL)
1. Set pressure relief valve to
2. Switch the pump OFF using the ON/OFF switch (Pos. 0).
3. Open the high-pressure filter and clean the filter insert. To
do so:
4. Unscrew the filter housing (1) by hand.
5. Remove the filter insert (2) and pull out the bearing spring
(3).
6. Clean all the parts with the corresponding cleaning agent.
If compressed air is available – blow through the filter
insert and bearing spring.
7. When mounting the filter ensure that the bearing ring (4)
in the filter insert is positioned correctly and check the
O-ring (5) at the filter housing for damage.
8. Screw on the filter housing by hand until it stops (a higher
tightening force only impedes later dismantling).
1
2
16
(pressure relief, circulation).
4
3
5
8.4
CLEANING THE AIRLESS SPRAY GUN
Clean the spray gun after each use.
i
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the airless spray gun.
CLEANING INTAKE FILTER IN AIRLESS SPRAY GUN
1. Unclip the top of the trigger guard (1) from the gun head.
2. Using the bottom of the trigger guard as a wrench, loosen
and remove the handle assembly (2) from the gun head.
3. Pull the old filter (3) out of the gun head. Clean or replace.
4. Slide the new filter, tapered end first, into the gun head.
5. Thread the handle assembly into the gun head. Tighten
with the trigger wrench.
6. Snap the trigger guard back onto the gun head.
1
ELITE 2000
3
2
Publicidad
