Publicidad
Idiomas disponibles
Idiomas disponibles
Stop using multi-component detergents
Add special salt and rinse aid to dispensers.
Set the water hardness to the highest level (6) and run an empty dishwasher.
Adjust the water hardness.
Adjust rinse aid setting.
Add rinse aid to the dispenser and adjust setting
7
Use rinse aid to prevent the formation of white water drops, lime scale spots, white
streaks that may occur on the dishes, as well as to improve the drying process. Con-
trary to popular belief, it not only serves to obtain a shiny dishes, but also to facilitate
drying. For this reason, make sure there is always sufficient amount of rinse aid in the
dispenser.
If the rinse aid indicator on the control panel lights up, add rinse aid to the dispenser.
To add rinse aid remove the dispenser lid by unscrewing it.
Remove the rinse reservoir cap by
lifting up the handle
Adjust the rinse aid dispenser
To achieve better drying results you can adjust how much rinse aid is used.
Follow these steps.
1. Close the door. Switch on the appliance.
2. Within 60 seconds of step 1, press and hold down the Programme
Press the Delay button to enter the settings. The rinse aid indicator blinks once per second.
3. Press the Programme
requirements. The following settings are available: d3->d4->d5->d1->d2 ->d3. The higher the number,
the more rinse aid is dispensed.
4. Press the on/off button to save the setting.
94
Pour the rinse aid into the
dispenser,
being careful not to
overfill.
button repeatedly to select the desired setting suitable for to your local
Selector position
d1-> Glass Light bright
d2-> Intensive Light bright
d3-> Glass and Intensive Light
bright
d4-> Selfcleaning Light bright
d5-> Selfcleaning and glass
Light bright
Close the cap after all.
button for at least 5 seconds.
Amount of rinse aid (mL)
1.2
2.4
3.6
4.8
6.0
Publicidad
