Haier I-MASTER 5 Serie Manual De Usuario página 13

6. Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, you could contact the Haier's Customer Support.
Problem
The Air fryer does not
work
White smoke comes out
of the appliance
Food are not
completely cooked
The display show error
code "E-1"
The display show error
code "E-2"
The display show error
code "E-3"
7. Technical data
Electrical connection
Power
8. Important information
Spares and Consumables
Always replace parts with genuine spares. These
are available from your local dealer. When
ordering parts always quote your model number.
Quality
Factories have been independently assessed for
quality. Our products are made using a quality
system which meets the requirements of ISO
9001.
Possible cause
The appliance is not plugged
in.
The frying bucket and basket
are not put into the appliance
properly.
You are cooking fatty
Ingredients.
The basket still contains greasy
residues from previous use.
The set temperature is too low
or cooking time is too short.
Too much ingredients in the
basket.
There is an open circuit in the
temperature sensor.
There is an short circuit in the
temperature sensor.
Overheat protection has been
triggered.
220-240V~50-60Hz
2000W
Check if the plug is inserted in the wall
socket.
Push the basket securely into the
appliance's body.
Carefully pour off any excess oil or fat
from the pan and then continue cooking.
Always clean the bucket and the basket
thoroughly after every use.
Increase the cooking temperature and
cooking time.
Decrease or place less batches of
ingredients into the basket for complete
frying.
Unplug it from the power source and
contact the customer support.
Unplug it from the power source and
contact the customer support.
Please let the appliance cool down before
turning it on again.
Your Guarantee
The guarantee conditions for this appliance are
as defined by our representative in the country
in which it is sold. Details regarding these
conditions can be obtained from the dealer
from whom the appliance was purchased.
The bill of sale or receipt must be produced
when making any claim under the terms of this
guarantee.
13
Solution
GB