Publicidad
Idiomas disponibles
Idiomas disponibles
Overview
COMMON ACTIONS AND UNIT RESPONSES
The following actions turn the unit on and activate the LCD Screen:
Press the LED Area Light
Power Button. (Refer to the
"LED Area Light" section.)
Press the Alternator
Check Button. (Refer to the
"Alternator Check" section.)
Press the AC Power Button.
(Refer to the "120V AC Power
Outlets" section.)
A beep will sound and the Area
Light will turn on. The Backlit LCD
Screen will turn on for 10 seconds
(only). The LCD Screen will continue
to display the Battery Status
Icon and Battery Voltage Indicator.
The unit remains on until the LED
Area Light Power Button is pressed
again to turn it off.
A beep will sound and the Backlit
LCD Screen will display the Battery
Status Icon, and the Alternator
Icon will flash. The unit remains on
until the Alternator Check Button is
pressed again to turn it off.
A beep will sound and the Backlit
LCD Screen will display the Battery
Status Icon; and the Digital Display
shows "AC", indicating the Dual
AC Outlets are ready to use. The
unit remains on until the AC Power
Button is pressed again to turn
it off.
Press the USB Power
Button. (Refer to the "USB
Ports" section.)
Press the Compressor
Power Button. (Refer to
the "Portable Compressor"
section.)
Whenever the clamps are
properly connected to a
battery (refer to the "Jump
Starter" section) ...
12
A beep will sound and the Backlit
will turn on. The LCD Screen will
display the Battery Status Icon,
Battery Voltage Indicator, and the
USB Icon; The unit remains on until
the USB Power Button is pressed
again to turn it off.
A beep will sound and the Backlit
LCD Screen will display the Battery
Status Icon, "XXX" PSI and the
Compressor Icon. If no further
actions are taken after 1 minute,
the unit will display the Battery
Status Icon and Battery Voltage
Indicator for 10 seconds before
automatically turning off.
... a beep will sound and the
Backlit LCD Screen will display
the Battery Status Icon, Battery
Voltage Indicator, the Clamp Icons,
and the "+" and "–" signs, as
well as the flashing Jump Starter
Icon. The unit remains on until the
clamps are disconnected from the
battery.
Publicidad
