Descargar Imprimir esta página

DeWalt DXAEPS14 Manual De Instrucciones página 6

Fuente de energía

Publicidad

Idiomas disponibles

Idiomas disponibles

• Working in the vicinity of a lead acid battery is dangerous. Batteries
generate explosive gases during normal battery operation. For this
reason, it is of the utmost importance that each time before using
the jump-starter you read this manual and follow instructions exactly.
• To reduce the risk of battery explosion, follow these instructions and
those published by the battery manufacturer and manufacturer of
any equipment you intend to use in the vicinity of the battery. Review
cautionary markings on these products and on the engine.
WARNING – Risk of serious injury or property damage:
• Never allow red and black clamps to touch each other or another
common metal conductor — this could cause damage to the unit
and/or create a sparking/explosion hazard.
WARNING – To reduce the risk of fire:
• Do not operate near flammable materials, fumes, dust or gases.
• Do not expose to extreme heat or flames.
CAUTION – To reduce the risk of injury or property damage:
• NEVER ATTEMPT TO JUMP-START OR CHARGE A FROZEN
BATTERY.
• Vehicles that have on-board computerized systems may be damaged
if vehicle battery is jump-started. Before jump-starting, read the
vehicle's owner's manual to confirm that external-starting assistance
is suitable.
• Jump-start procedures should only be performed in a safe, dry,
well-ventilated area.
• Always store battery clamps properly when not in use.
• When using this unit close to the vehicle's battery and engine, stand
the unit on a flat, stable surface, and be sure to keep all clamps, cords,
clothing and body parts away from moving vehicle parts.
• Make sure to connect the clamps with correct polarity. Damage
caused by improper connection is not covered by the Warranty.
• Do not expose battery to fire or intense heat since it may explode.
Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Place this unit as far away from the battery as cables permit.
• Never allow battery acid to come in contact with this unit.
• Do not operate this unit in a closed area or restrict ventilation in any
way.
• This system is designed to be used only on vehicles with a 12 volt DC
battery system. Do not connect to a 6 volt or 24 volt battery system.
• This system is not designed to be used as a replacement for a
vehicular battery. Do not attempt to operate a vehicle that does not
have a battery installed.
• Excessive engine cranking can damage a vehicle's starter motor. If
the engine fails to start after the recommended number of attempts,
discontinue jump-start procedures and look for other problems that
may need to be corrected.
• Do not use this jump starter on a watercraft. It is not qualified for
marine applications.
• Although this unit contains a non-spillable battery, it is recommended
that unit be kept upright during storage and recharging. To avoid
possible damage that may shorten the unit's working life, protect it
from direct sunlight, direct heat and/or moisture.
Specific Safety Instructions for
Compressors
WARNING – Burst hazard: Bursting articles can cause serious
injury.
• Carefully follow instructions on articles to be inflated.
• Never exceed the recommended pressure listed in instructions
on articles to be inflated. If no pressure is given, contact article
manufacturer before inflating.
• Always monitor the pressure on the LCD Screen.
CAUTION: To reduce the risk of property damage:
6

Publicidad

loading