Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING – To reduce the risk of serious injury or property
damage:
• Follow all safety instructions found in the "Specific Safety Instructions
for Jump Starters" section of this instruction manual.
• If the clamps are connected incorrectly with regard to polarity, the unit
will sound a continuous alarm until the clamps are disconnected. The
Backlit LCD Screen will display the Battery Status Icon, the Battery
Voltage Indicator and the Clamp Icons. The "+" and"–" signs above
the Clamp Icons, the Arrow Icons and the Alarm Icon will flash. The
Backlit LCD Screen will display the following:
Disconnect the clamps and reconnect to battery with correct polarity.
• Never touch red and black clamps together. This can cause
dangerous sparks, power arcing, and/or explosion.
If the red and black clamps touch each other, the unit will sound a
continuous two-second alarm every ten seconds until the clamps
are separated. The Backlit LCD Screen will display the following:
The Battery Status Icon and Battery Voltage Indicator light solid.
The Alarm Icon, Clamp Icons and the "+" and"–" signs will flash.
Immediately separate the clamps and do not allow them to touch
again.
• If the unit is overheated during the jump starting process, the thermal
protection will activate and the Backlit LCD Screen will display the
following:
The Battery Status Icon and Battery Voltage Indicator light solid.
The Alarm Icon will flash. Allow the unit to cool for 10-30 minutes
before use.
• Always disconnect the negative (black) jumper cable first, followed by
the positive (red) jumper cable, except for positive grounded systems.
PROCEDURE
Take the following steps, observing all cautions and warnings in the
"Important Safety Instructions" section at the front of this manual.
1. Turn off vehicle ignition and all accessories (radio, A/C, lights,
connected cell phone chargers, etc.). Place vehicle in "park" and
set the emergency brake.
2. Remove jumper clamps from clamp tabs. Connect the red clamp
first, then the black clamp.
3. Procedure for jump-starting a NEGATIVE GROUNDED
SYSTEM (negative battery terminal is connected to chassis)
(MOST COMMON)
3a. Connect positive (+) red clamp to vehicle battery's positive
terminal.
3b. Connect negative (–) black clamp to chassis or a solid, non-
moving, metal vehicle component or body part. Never clamp
15
Publicidad
