Publicidad
Idiomas disponibles
Idiomas disponibles
2. Recharging the battery after each use will prolong battery life;
frequent heavy discharges between recharges and/or overcharging
will reduce battery life.
3. Make sure all other unit functions are turned off during recharging,
as this can slow the recharging process.
CAUTION – Risk of property damage: Failure to keep the battery
charged will cause permanent damage and result in poor jump starting
performance.
IMPORTANT: If you know the unit is discharged, but the Battery Icon
displays four solid bars as if the unit is fully charged when connected to
a charging power source, this may be due to the internal battery having
high impedance. The manufacturer suggests leaving the unit charging
for a period of 40 hours using the supplied 120V AC Charging Adapter
before use.
Charging/Recharging Using the
Supplied Charging Adapter
1. Lift the protective cover of 12V DC Charging Port located on the
back of the unit (refer to Fig. 3 to locate). Insert the barrel connector
of the AC Charging Adapter into the DC charging port. Insert the
plug end into a (powered) standard North American 120 volt 60Hz
outlet. When the unit is properly connected to an AC power source,
the LCD Screen will display the following:
The bars on the Battery Status Icon represent the charge level of
the unit's internal battery. The bars on the Battery Status Icon will
change from empty to solid (bottom to top) repeatedly to indicate
the unit is charging. The Backlight will turn on for 10 seconds (only).
2. Charge for approximately 40 hours or until the Battery Status Icon
shows 4 solid bars.
3. When charging is complete, disconnect the AC Charging Adapter –
first unplug the adapter from the AC power source, then disconnect
the barrel connector from the unit.
Jump-Starter
A. For negative-grounded systems (most common), connect the
positive (red) clamp to the positive ungrounded battery post
and the negative (black) clamp to the vehicle chassis or engine
block away from the battery. Do not connect the clamp to the
carburetor, fuel lines or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or engine block.
B. For positive-grounded systems, connect the negative (black)
clamp to the negative ungrounded battery post and the positive
(red) clamp to the vehicle chassis or engine block away from the
battery. Do not connect the clamp to the carburetor, fuel lines or
sheet-metal body parts. Connect to a heavy gauge metal part of
the frame or engine block.
IMPORTANT: . All features
must be turned off with the
exception of the Area Light
when jump-starting. The unit
is intended to be used only in
the upright position. The unit
must be kept upright during
use. See the illustration
to the right for correct
orientation.
14
Publicidad
