Descargar Imprimir esta página

DeWalt DXAEPS14 Manual De Instrucciones página 25

Fuente de energía

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Possible Solution
USB Port will not
Make sure the USB Power Button is in
the on position.
power device
A fault condition exists in one of the
USB Ports. Refer to the Important
Notes in the "USB Ports" section to
remedy any faults.
Make sure that the USB device plugged
into the USB-A port does not exceed
15W; the USB device plugged into
USB-C port does not exceed PD
25W; or the total drained power of
the USB-A port and USB-C port do
not exceed 15W when they are used
simultaneously.
Some USB-powered household
electronics will not operate with this
USB charging/power Port. Check the
manual of the corresponding electronic
device to confirm that it can be used
with this type of USB charging/power
Port.
Check that the unit has a full charge.
Recharge the unit if necessary.
LED Area Light does
Make sure the Area Light Power Button
is in the on position
not come on
Check that the unit has a full charge.
Recharge the unit if necessary.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
e
accessories with this unit could be hazardous. To reduce the risk of
injury, only D
WALT recommended accessories should be used with
e
this product.
If you need assistance regarding accessories, please contact the
manufacturer at 1-888-394-3392 or CustomerService@dewalt12volt.
com.
Technical Assistance
For Customer Service or Technical Assistance, contact the manufacturer
at 1-888-394-3392 or CustomerService@dewalt12volt.com.
One-Year Limited Manufacturer's
Warranty
This warranty gives you, the original retail purchaser, specific legal rights
and you may have other rights which vary in certain states or provinces.
This product is not intended for commercial use.
The manufacturer, Baccus Global LLC, warrants this product against
defects in materials and workmanship for a period of ONE (1) YEAR
commencing from the date of retail purchase by the original end-user
purchaser or from the date of delivery of the good, whichever occurs
later ("Warranty Period").
If there is a defect and a valid claim is received by the manufacturer
within the Warranty Period, the defective product can be replaced
in the following ways: (1) Return the product to the manufacturer for
replacement. Proof of purchase may be required by manufacturer. (2)
Return the product to the retailer where product was purchased for an
exchange (provided that the store is a participating retailer). Returns
to retailer should be made within the time period of the retailer's return
25

Publicidad

loading