Publicidad
Idiomas disponibles
Idiomas disponibles
Important Notes Concerning the USB Ports
1. The USB-A Port provides up to 15W output power. The USB-C
Port provides up to PD 25W output power. The total output is up
to 5V/15W when the USB-C and USB-A used simultaneously.
2. When the USB Ports are in use, the unit will monitor for the following
USB fault conditions on all the USB Ports: low battery voltage fault,
overload and short circuit. In any of these cases, the USB Ports
will automatically shut down. Should this occur:
a. Disconnect the USB-powered device and press the USB
Power Button again to turn off the USB Ports immediately.
b. Make sure the unit does not need to be recharged.
c. Allow the unit to cool down for several minutes before
attempting to use the USB Ports again.
d. If a fault occurs again, make sure that draw of the USB
devices plugged into the USB Ports do not exceed the
maximum rating.
e. If an individual USB device is within specifications and the
fault occurs, have the USB device checked for malfunction
and do not continue to use it with these USB Ports.
3. This unit's USB Ports do not support data communication. They
only provide power to external USB-powered devices.
4. Some household USB-powered electronics will not operate with
this unit.
USING THE USB PORTS
1. Press the USB Power Button to turn on all of the USB Ports. A
beep will sound, and the LCD Screen will continuously display the
following:
The Battery Status Icon and Battery Voltage Indicator will light
solid, as well as the USB Icon, indicating the USB Ports are ready
to use.
2. Plug the USB-powered device into the USB Ports and operate
normally.
3. Press the USB Power Button again to turn off the USB Ports.
Periodically check the unit's battery status on the Backlit LCD Screen.
Four solid bars in the Battery Icon indicates a full battery. When the
battery level is nearly empty with only one solid bar or completely
empty with 4 empty bars, the unit must be recharged at this time or
the unit's built-in low voltage protection will activate and the USB Ports
will automatically shut down.
IMPORTANT: Make sure the USB Ports are turned off when the unit
is being recharged or stored.
LED Area Light
The built-in LED Area Light consists of two banks of two LEDs (one on
the right hand side, one on the left hand side of the back of the unit).
It is controlled by the Area Light Power Button on the control panel
(refer to Fig. 1 to locate).
1. Press the Area Light Power Button once to turn the light on.
2. Press the Area Light Power Button again to turn the Area Light off.
When the Area Light Power Button is pressed to turn it on, a beep will
sound. The Backlit LCD Screen will turn on for 10 seconds (only) and
22
Publicidad
