Publicidad
Idiomas disponibles
Idiomas disponibles
The Digital Display will show the FULL Battery Status Icon, the
"AC" and Fault Icon on the LCD Screen will flash.
3. If a thermal, overload or short circuit fault condition exists, the AC
Power Outlets will shut down automatically and the Backlit LCD
Screen will display the following until the fault is corrected:
The Battery Status Icon will light solid; the "AC" on the Digital
Display and the Fault Icon on the LCD Screen will flash.
Should any of the above fault conditions occur:
1. Disconnect the appliance from the unit.
2. Press the AC Power Button to turn the AC Power Outlet off.
3. Make sure the unit does not need to be recharged.
4. Allow the unit to cool down for several minutes.
5. Make sure the rating of the appliance plugged into the unit is
500 watts or lower and that the appliance cord and plug are not
damaged.
6. Assure there is adequate ventilation around the unit before
proceeding.
USING THE DUAL 120 VOLT AC OUTLETS
The two 120 Volt AC Outlets are located on the front of the unit (refer
to Fig. 2 to locate). The two outlets support a combined maximum
power draw of 500 watts.
1. Press the AC Power Button to turn on both 120V AC Power
Outlets. A beep will sound and the LCD Screen will display the
following:
The Battery Status Icon lights solid and the Digital Display shows
"AC," indicating the Dual AC Outlets are ready to use.
2. Pull and hold the protective cover of the left AC outlet
counterclockwise or the protective cover of the right AC outlet
clockwise to expose the outlets. Insert the 120 volt AC plug from
the unit into one of the 120 Volt AC Outlets.
3. Switch on the unit and operate as usual.
NOTE: Ensure that the wattage of all equipment simultaneously
plugged into both 120V AC Power Outlets does not exceed 500
watts continuous.
4. Press the AC Power Button again to turn off the 120V AC Power
Outlets.
Monitor the unit's internal battery status on the LCD Screen. Four solid
bars in the Battery Icon indicates a full battery. When the battery level
is nearly empty with only one solid bar, the unit MUST be recharged
at this time.
Make sure the AC Power Outlets are turned off when the unit is being
recharged or stored.
USB Ports
The USB Power Button and the two USB Ports are located on the front
of the unit. Refer to Fig. 1 and 2 to locate.
21
Publicidad
